Table of Contents
IndraDrive Mi Drive Systems with KCU02, KSM02,
KMS02/03, KMV03, KNK03, KLC03
9
Mounting and installation
9.1
Introduction
9.1.1
Important notes
Safety
Qualified technical staff
Handling the devices
WARNING
Install the motors only when they have been de-energized and are not
connected electrically.
Use suitable lifting gear, protective equipment and protective clothing during
transport.
Observe the safety instructions contained in the preceding chapters.
Carry out all working steps with particular care. In this way, you minimize the
risk of accidents and damages.
Any work at the installation and the drives or in their vicinity may be carried
out only by appropriately trained technical staff.
Make sure that all persons carrying out installation work, maintenance work
or operational activities at the installation are adequately familiar with the
contents of this documentation, as well as with all warnings and
precautionary measures contained therein.
Qualified technical staff must be trained, instructed and qualified to switch
electrical circuits and devices on and off in accordance with technical safety
regulations, to ground them and to mark them. Qualified technical staff must
possess appropriate safety equipment and have been trained in first aid.
CAUTION
Avoid mechanical stressing, throwing, tipping or dropping of the products.
Use only suitable lifting gear.
Use suitable protective equipment and protective clothing during transport.
Wear safety shoes.
Protect the products against dampness and corrosion.
At delivery, the output shafts have protective sleeves and the connection
points have covers. During transport and storage, the protective sleeves and
covers must be attached to the device.
●
Remove the protective sleeves just before mounting.
●
Also use the protective sleeves if you return the goods.
Mounting and installation
Injuries caused by live parts! Lifting of heavy
loads!
Injuries or damage and invalidation of the
warranty due to improper handling!
R911335703_Edition 04 Bosch Rexroth AG
277/407
Table of Contents
