Kenwood NEXEDGE NX-200 Function Reference page 440
Hide thumbs
Also See for NEXEDGE NX-200:
- Service manual (172 pages) ,
- Instruction manual (136 pages) ,
- Brochure (12 pages)
Table of Contents
16 COMMUNICATIONS IN AN EMERGENCY
16.6 Placing the Transceiver Automatically in Emergency Mode
Exiting Lone Worker Mode
1
Do either of the following operations while the transceiver is in Lone Worker Mode.
• Press the Lone Worker key.
• Select a channel or GID where Lone Worker is disabled.
• Press the Menu key to enter Menu Mode, and select "Lone
Worker" and then select "OFF".
The "
" icon disappears and then the transceiver exits Lone
Worker Mode. The Key Beep B sounds from the transceiver by
pressing the Lone Worker key.
Note
• If "Transmit/Receive Inhibit" is configured for the Lone Worker Type, Lone Worker cannot be turned On or Off in Menu Mode. (Refer to
Lone Worker Type on page
• If a PF key is pressed or the transceiver transmits by a user pressing the PTT switch while the timer for Lone Worker Interval is
counting down, the timer for Lone Worker Interval is reset and then restarts counting down from the beginning. However, if the
communication using a PC Command takes place, the timer for Lone Worker Interval continues counting down without being reset.
• Lone Worker cannot be activated while the transceiver is in the Stun state or while in Transceiver Password Mode.
• Lone Worker can be activated even if the Key Lock state is activated while the transceiver is in Lone Worker Mode.
• If the transceiver migrates from Lone Worker Mode to Emergency Mode, the transceiver exits Emergency Mode by a user pressing the
Emergency key for a length of time greater than the length of time configured for the Emergency-key Delay Time.
• If a scan initiates while the transceiver is in Lone Worker Mode, the scan initiates with Lone Worker Mode enabled. If the scan starts
while the transceiver is in a mode other than Lone Worker mode, the scan starts with Lone Worker Mode disabled.
Configuration using KPG-111D/ DN
•
Assigning functions to the PF keys on the transceiver (
•
Configuring the Lone Worker to be enabled or disabled (
8.9.7 Lone Worker)
Functions in Lone Worker Mode
The following functions are relevant to Lone Worker Mode.
•
Lone Worker Type
•
Lone Worker Interval
•
Duration of Lone Worker Tone
Lone Worker Type
Lone Worker Type can be used to configure how the transceiver behaves in Lone Worker Mode. The transceiver behaves
as below while in Lone Worker Mode according to the configuration for Lone Worker Type.
FUNC (K)/Ver 4.00
406.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
See
FPRG 8.12 Key Assignment Window)
See
FPRG 8.3.4 Page 2 Tab, 8.7.18 Lone Worker and
CONTENTS
Mobile
INDEX
406
Chapters
Table of Contents
