Kenwood NEXEDGE NX-200 Function Reference page 185
Hide thumbs
Also See for NEXEDGE NX-200:
- Service manual (172 pages) ,
- Instruction manual (136 pages) ,
- Brochure (12 pages)
Table of Contents
8 NXDN CONVENTIONAL SYSTEM
8.9 Sending and Receiving a Status Message (Status Call)
Sending a Status Message
This section describes how to send a Status Message in Status Mode.
The transceiver enters Status Mode with one of the following operations, and then the transceiver will send a Status
Message.
Status (FleetSync/ NXDN), Individual + Status (NXDN) or Group + Status (NXDN) key
Pressing the Status (FleetSync/ NXDN) key places the transceiver in Status Mode. In this case, a Status Message is
addressed to a Base ID.
Or, pressing the Individual + Status (NXDN) or Group + Status (NXDN) key places the transceiver in Individual Call
Mode or Group Call Mode. The transceiver enters Status Mode by pressing the Menu ([
the target Unit ID or Group ID.
Menu key
The transceiver enters Status Mode when "Status (FleetSync/NXDN)" is selected to after entering Menu Mode by
pressing the Menu key. In this case, a Status Message is addressed to a Base ID.
Or, if "Individual + Status (NXDN)" or "Group + Status (NXDN)" is selected after entering Menu Mode by pressing the
Menu key, the transceiver enters Individual Call Mode or Group Call Mode. The transceiver enters Status Mode by
pressing the Menu ([
page
23.)
Keypad entry
If "Status (FleetSync/NXDN)" is configured for Keypad Operation, pressing the [0] to [9] keys on the transceiver keypad
causes the transceiver to enter Status Mode. In this case, a Status Message is addressed to a Base ID.
If "Individual + Status (NXDN)" is configured for Keypad Operation, pressing the [0] to [9] keys on the keypad places
the transceiver in Individual Call Mode. The transceiver enters Status Mode by a user pressing the Menu ([
key after selecting the target Unit ID. (Refer to
Note
For operating in Individual Call Mode or Group Call Mode, refer to the information on the various call types of an NXDN.
Operating the Transceiver
Sending a Status Message by list selection
1
Select one of the following operations to place the transceiver in Status Mode.
• Press the Status (FleetSync/NXDN) key.
The transceiver enters Status Mode. In this case, a Status
Message is addressed to a Base ID.
• Press the Individual + Status (NXDN) key.
Pressing the Menu ([
target transceiver's Unit ID places the transceiver in Status
Mode.
• Press the Group + Status (NXDN) key. (NXDN Conventional
System)
Pressing the Menu ([
target transceiver's Group ID places the transceiver in Status
Mode.
• Press the Group + Status (NXDN) key after selecting the
target transceiver's Group ID. (NXDN Trunking System)
The transceiver enters Status Mode.
Or, the transceiver enters Status Mode by a user pressing the
Menu key or using a keypad. In this case, the following
operations are identical.
FUNC (K)/Ver 4.00
]) or [*] key after selecting the target Unit ID or Group ID. (Refer to
Keypad Operation on page
]) or [*] key after a user selects the
]) or [*] key after a user selects the
]) or [*] key after selecting
3.4 Using Menu Mode on
21.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS
INDEX
]) or [*]
151
Chapters
Table of Contents
