Kenwood NEXEDGE NX-200 Function Reference page 595
Hide thumbs
Also See for NEXEDGE NX-200:
- Service manual (172 pages) ,
- Instruction manual (136 pages) ,
- Brochure (12 pages)
Table of Contents
APPENDIX
Installing the Transceiver in a Vehicle (Mobile Only)
Installing the Transceiver in a Vehicle (Mobile Only)
This section describes how to install the transceiver in a vehicle.
Various electronic equipment in a vehicle may malfunction if they are not properly protected from the radio frequency energy
which is present while transmitting. Electronic fuel injection, anti-lock braking systems (ABS), and cruise control systems are
typical examples of equipment that may malfunction. If the vehicle contains such equipment, ensure that they will perform
normally after installing the transceiver.
Before installing the transceiver, always check how far the mounting screws will extend below the mounting surface. When
drilling mounting holes, be careful not to damage vehicle wiring or parts.
Supplied Parts and Required Tools
Ensure that the transceiver and the following supplied parts are prepared.
Table 1-11 Accessories Supplied with NX-700/ NX-700H/ NX-800/ NX-800H/ NX-900
Microphone (with cable)
Microphone hanger (with 4 x 6 mm (1.6 x 0.24 inches) self-tapping screws)
DC power cable
Fuse (15 A)
Mounting bracket
Screw set
5 x 6 mm self-tapping screw (4 pieces)
Hex-headed screw with washer (4 pieces)
Spring washer (4 pieces)
Flat washer (4 pieces)
Also, the following tools are required for installing the transceiver.
•
6 mm (0.24 inches) or larger electric drill
•
4.2 mm (0.168 inches) drill bit (This is used for fixing the mounting bracket by using the self-tapping screws.)
•
Circle cutters
FUNC (K)/Ver 4.00
Item
Part Number
Quantity
T91-0639-XX
1
J19-1584-XX
1
E30-7523-XX
1
F52-0024-XX
2
J29-0726-XX
1
N99-2039-XX
1
CONTENTS
INDEX
561
Chapters
Table of Contents
