Kenwood NEXEDGE NX-200 Function Reference page 349
Hide thumbs
Also See for NEXEDGE NX-200:
- Service manual (172 pages) ,
- Instruction manual (136 pages) ,
- Brochure (12 pages)
Table of Contents
12 FleetSync
12.4 Making a Selective Call
Fleet Call
Pressing the PTT switch or the Side 2 key (Portable), or the Square key (Mobile) causes the transceiver to initiate a call to
the target transceiver.
The transceiver only controls the mute and does not enter Call Mode when receiving a call from a fleet which is not
registered in the ID List.
The LCD will restore to normal state by pressing a key on the transceiver. If Auto Reset Timer is configured, the LCD will
restore to normal state after the time configured for Auto Reset Timer elapses.
Supervisor Call/ Broadcast Call
If the ID is configured for ID List, pressing the PTT switch or the Side 2 key (Portable), or the Square key (Mobile) causes
the transceiver to initiate a call to the target transceiver.
The transceiver only controls the mute and does not enter Call Mode when receiving a call from a party which is not
registered in the ID List.
The LCD will restore to normal state by pressing a key on the transceiver. If Auto Reset Timer is configured, the LCD will
restore to normal state after the time configured for Auto Reset Timer elapses.
ID List
The transceiver uses an individual FleetSync ID to establish communication if FleetSync is enabled. The desired
FleetSync IDs must be preconfigured in the transceiver using KPG-111D/ DN prior to use of the transceiver. A maximum of
1000 FleetSync IDs can be configured for FleetSync ID List.
Configuration
Fleet of the FleetSync ID is configured. A user can register "ALL" or a number between 100 and 349.
Fleet
ALL allows initiation of a call to all Fleets.
ID of the FleetSync ID can be configured. A user can register "ALL" or a number between 1000 and 4999.
ID
"ALL" allows initiation of a call to all IDs.
The caller's ID Name is configured. A maximum of 14 characters can be configured for the ID Name.
ID Name
If the caller's ID Name is registered in the ID List, the ID Name appears on the main display when the transceiver
receives a selective call.
The permission or inhibition of transmission of the receiving party can be configured.
The ID for which "Yes" is configured for Transmit Inhibit does not appear on the ID selection display in Selcall Mode,
and a user cannot select the ID in Selcall Mode.
Transmit Inhibit
If the transceiver receives a call from an ID for which "Yes" is configured for Transmit Inhibit, the caller's ID Name
appears on the main display. In this case, a user cannot initiate a call to the party even if the user attempts to
respond by pressing the PTT switch.
Configuration using KPG-111D/ DN
Configuring the ID List (
FUNC (K)/Ver 4.00
Table 12-6 ID List Configuration
See
FPRG 8.16.5 ID List Tab)
Description
CONTENTS
INDEX
315
Chapters
Table of Contents
