Kenwood NEXEDGE NX-200 Function Reference page 170
Hide thumbs
Also See for NEXEDGE NX-200:
- Service manual (172 pages) ,
- Instruction manual (136 pages) ,
- Brochure (12 pages)
Table of Contents
8 NXDN CONVENTIONAL SYSTEM
8.6 Initiating an Individual Call After Ensuring That the Target Party Is Available for Communications (Individual Call
"<>" appears on the main display, and the
transceiver waits to receive an acknowledgment message from
the receiving transceiver.
2
Receive an acknowledgment message from the receiving transceiver.
The Call In Progress Tone sounds from the transceiver, the ID for
the receiving transceiver appears on the main display, and the
transceiver becomes enabled for the transmission by means of
an Individual Call.
Receiving an acknowledgment message while the PTT switch is
being pressed initiates an Individual Call. If PTT Proceed Tone is
configured to be enabled, a PTT Proceed Tone sounds from the
transceiver at this time.
3
Press the
PTT
switch.
The Individual Call is initiated.
Note
• If the Call Request Tone is enabled, a Call Request Tone sounds from the transceiver when a call request for an Individual Call
(Individual Call Acknowledge Request) is initiated. Also, if the Call Processing Tone is enabled, a Call Processing Tone sounds from
the transceiver until the transceiver receives an acknowledgment message from the receiving transceiver after the call request for an
Individual Call (Individual Call Acknowledge Request) is sent. (Refer to
Initiated (Call Request Tone)/ Notifying the User with a Tone That a Call Request Is in Progress (Call Processing Tone) on page
• If PTT Proceed Tone is enabled, a Proceed Tone sounds from the transceiver when the transceiver becomes ready for
communications after the PTT switch is pressed. (Refer to
Tone) on page
92.)
• While the transceiver is on standby to receive an acknowledgment message from the receiving transceiver, canceling the call is
possible by pressing the Side 1 key (Portable), the Triangle key (Mobile) or the [#] key.
• The transmitting transceiver sends a message requesting another acknowledgment if the time configured for Maximum
Acknowledgment Wait Time elapses before receiving a response message from the receiving transceiver. The transmitting transceiver
can send a message requesting an acknowledgment up to the number of times configured for Number of Retries until the transceiver
receives a response message. (Refer to
• The transceiver cancels the call processing for the following. In this case, "<>" appears on the main display for 1 sec.
• If the transceiver cannot receive an acknowledgment message from the receiving transceiver even if a message requesting an
acknowledgment has been sent for the number of times configured in the Number of Retries. (Refer to
page
147.)
• If the receiving transceiver rejects the incoming call, and the transmitting transceiver receives the notification message for
cancellation.
• If the time configured for the Initiating/Incoming Reset Time elapses before the transceiver receives an acknowledgment
message from the receiving transceiver. (Refer to
Acknowledgment Message (Initiate/Incoming Reset Time) on page
FUNC (K)/Ver 4.00
Using Sound to Notify the Timing to Start Communications (PTT Proceed
Maximum ACK Wait Time on page
Configuring the Maximum Length of Time to Wait to Receive an
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Notifying the User with a Tone That a Call Request Has Been
147,
Number of Retries on page
140.)
CONTENTS
Mobile
Mobile
212.)
147.)
Number of Retries on
INDEX
136
Chapters
Table of Contents
