Kenwood NEXEDGE NX-200 Function Reference page 233
Hide thumbs
Also See for NEXEDGE NX-200:
- Service manual (172 pages) ,
- Instruction manual (136 pages) ,
- Brochure (12 pages)
Table of Contents
9 NXDN TRUNKING SYSTEM
9.3 Registration in an NXDN Trunking System
9.3
Registration in an NXDN Trunking System
Registration is a function that enables registration with the system the location data of the transceiver at the time the
transceiver searches for or acquires a control channel, for instance by turning the transceiver ON. By registering the
location of the transceiver, the system can recognize which site the transceiver belongs to and specifies the site where the
communication can be established. Therefore, in the case of Individual Call, a request for an incoming call can
immediately be placed with a site where the called transceiver resides; hence, the system can effectively be operated.
Group-registration is a function that enables the transceiver to register with the system groups to be used. By registering
groups, the system can recognize in which site the transceiver waiting for a Group Call resides. Therefore, in the case that
a Group Call is made in a multi-site system, the system can limit the registered sites as coverage for the call; hence, the
system can effectively handle a Group Call.
Registration Clear is a function that enables clearing from the system of the transceiver registration information, for
instance by turning the transceiver OFF. This function can be used on the system side to recognize a transceiver that does
not reside in the site.
Registering the Own Unit ID in a System (Registration)
The transceiver can register its own Unit ID in the system.
Conditions for the Transceiver to Begin Registration
The transceiver begins Registration under the following conditions.
•
When the transceiver is turned ON
The transceiver begins Registration upon acquisition of a control channel after the transceiver is turned ON.
•
If roaming to different sites
The transceiver begins Registration when the transceiver roams to different sites regardless of single-site system
or multi-site system.
•
If the zone is changed to a zone in an NXDN Trunking System
The transceiver will begin Registration if a zone in an Analog Conventional system or LTR Trunking system is
changed to a zone in an NXDN Trunking system by a user operating the transceiver and a control channel is
acquired.
FUNC (K)/Ver 4.00
Registration/
Group-registration
Registration Clear
Turning the
transceiver ON
Directional movement for a roaming transceiver
Figure 9-4 Registration/ Group-registration/ Registration Clear
System A
Site 1A
Site 2A
Turning the
transceiver OFF
CONTENTS
INDEX
199
Chapters
Table of Contents
