Kenwood NEXEDGE NX-200 Function Reference page 360
Hide thumbs
Also See for NEXEDGE NX-200:
- Service manual (172 pages) ,
- Instruction manual (136 pages) ,
- Brochure (12 pages)
Table of Contents
12 FleetSync
12.6 Sending and Receiving a Status Message (Status Call)
If the transceiver cannot connect to the repeater (LTR
Trunking System):
"OUT OF RANGE" appears on the main display.
If the transmission is canceled:
While "SEND DATA" is appearing , the Side 1 (NX-200/
NX-210/ NX-300/ NX-410/ NX-411) or the Triangle key
(Mobile) needs to be pressed. "CANCEL" appears on the main
display, and the transmission is canceled.
Sending a Status Message using Manual Dialing
To send a Status Message using Manual Dialing, Manual Dialing must be enabled using KPG-111D/ DN.
1
Select one of the following operations to place the transceiver in Status Mode.
• Press the Status (FleetSync/NXDN) key.
The transceiver enters Status Mode. In this case, a Status
Message is addressed to a Target Fleet/ ID.
• Press the Selcall + Status (FleetSync) key.
Pressing the Menu ([
target transceiver's Selcall ID places the transceiver in Status
Mode.
Or, the transceiver enters Status Mode by a user pressing the
Menu key or using a keypad. In this case, the following
operations are identical.
FUNC (K)/Ver 4.00
]) or [*] key after a user selects the
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS
INDEX
326
Chapters
Table of Contents
