Kenwood NEXEDGE NX-200 Function Reference page 252
Hide thumbs
Also See for NEXEDGE NX-200:
- Service manual (172 pages) ,
- Instruction manual (136 pages) ,
- Brochure (12 pages)
Table of Contents
9 NXDN TRUNKING SYSTEM
9.6 Initiating an Individual Call After Ensuring That the Target Party Is Available for Communications (Message Trunked (Enhanced))
2
Press the
PTT
switch,
A message requesting the connection is sent to the system.
3
Receive from the system a message for traffic channel assignment.
A Call In Progress Tone sounds from the transceiver, the ID of the
transmitting transceiver appears on the main display, and the
transceiver becomes enabled for communications.
Receiving a message for traffic channel assignment while the
PTT switch is being pressed and held starts transmission by an
Individual Call. If PTT Proceed Tone is configured to be enabled,
a PTT Proceed Tone sounds from the transceiver at this time.
Note
• The DTMF code can be sent during the call by pressing one of the [0] key to [9] key, the [*] key or the [#] key while pressing and
holding the PTT switch.
• If the Call Request Tone is enabled, a Call Request Tone sounds from the transceiver when a message requesting the connection is
transmitted. Also, if the Call Processing Tone is enabled, a Call Processing Tone sounds from the transceiver while the transceiver is
on standby to receive from the system a message for traffic channel assignment. (Refer to
Request Has Been Initiated (Call Request Tone)/ Notifying the User with a Tone That a Call Request Is in Progress (Call Processing
Tone) on page
212.)
• For Mobile, if the Mic Off-hook Connect is enabled, a message requesting connection is sent by placing the microphone in the off-hook
state.
• During Step 1, the transceiver can reject an incoming call by pressing the Side 1 key (Portable), the Triangle key (Mobile) or the [#]
key.
• The Individual Call ends by pressing the Side 1 key, (Portable), the Triangle key (Mobile) or the [#] key. For Mobile, if the Mic On-hook
Disconnect is enabled, an Individual Call terminates by placing the microphone in the on-hook state.
• If the transceiver receives an Emergency Call, the transceiver automatically sends a message requesting a connection regardless of
the configuration for the Automatic Response.
• By pressing the PTT switch, the transmitting transceiver can be called.
• If the received Unit ID is configured in the Unit ID List, an Alert Tone sounds from the transceiver according to the configuration for Alert
Tone (Paging Call) of the corresponding Unit ID. If the received Unit ID is not registered in the Unit ID List, the Alert Tone sounds from
the transceiver according to the configuration for Alert Tone (Paging Call) which is commonly used.
FUNC (K)/Ver 4.00
Side 2
key (Portable), or the
Square
key (Mobile).
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Notifying the User with a Tone That a Call
CONTENTS
Mobile
Mobile
INDEX
218
Chapters
Table of Contents
