Kenwood NEXEDGE NX-200 Function Reference page 254
Hide thumbs
Also See for NEXEDGE NX-200:
- Service manual (172 pages) ,
- Instruction manual (136 pages) ,
- Brochure (12 pages)
Table of Contents
9 NXDN TRUNKING SYSTEM
9.7 Making a Group Call (Transmission Trunked)
Sending an Acknowledgment Automatically (Automatic Response)
Automatic Response is the function to automatically send a message requesting the connection upon receipt of a
message requesting an acknowledgment for an Individual Call.
If this function is enabled, the transceiver automatically sends a message requesting the connection upon receipt of a
message requesting an acknowledgment for an Individual Call.
If this function is disabled, the transceiver automatically sends no message requesting the connection even if the
transceiver has received message requesting an acknowledgment for an Individual Call. In this case, a message
requesting the connection can be sent manually by a user operating the transceiver. Refer to "l If Automatic Response is
disabled:" in
Receiving an Individual Call (Message Trunked (Enhanced)) on page 217
Note
In multiple systems, Automatic Response can be configured for each system.
Configuration using KPG-111D/ DN
•
Configuring the Automatic Response to be enabled or disabled (Single System) (
•
Configuring the Automatic Response to be enabled or disabled (Multiple Systems) (
9.7
Making a Group Call (Transmission Trunked)
Group Call can be used to engage in 2-way group voice calls by initiating a call to a group.
The transceiver can initiate a call to the transceivers having the same Group ID by specifying the Group ID. The
transceiver can also initiate a call to all transceivers by specifying the Group ID for which "ALL" is configured.
"Transmission Trunked" needs to be configured for Trunking Type on both the transmitting transceiver and the receiving
transceiver to initiate a Group Call in an NXDN Trunking system. "Transmission Trunked" or "Message Trunked" also
needs to be configured for Trunking Type on the system. (Refer to
Initiating a Group Call (Transmission Trunked)
Group Call can be started by one of the following methods.
CH/GID Up and CH/GID Down keys
The transceiver starts a Group Call when the PTT switch is pressed after selecting a Group ID by pressing the CH/GID
Up or CH/GID Down key.
Selcall on PTT
The transceiver starts a Group Call using Group ID configured for GID when the PTT switch is pressed on GID where
"Group Call" is configured for Selcall on PTT
PC Command
The transceiver starts a Group Call upon the receipt of a PC command from the communication port.
FUNC (K)/Ver 4.00
for instruction.
FPRG 8.19.4 Trunking Tab)
See
See
Trunking Type on page
203.)
CONTENTS
FPRG 8.20.3 General Tab)
INDEX
220
Chapters
Table of Contents
