Registration Of The Ignition Key; Procedure After Ecm Replacement; Procedure After Immobilizer Control Module (Icm) Replacement; Special Tool - Suzuki GRAND VITARA 2005 Service Manual
Hide thumbs
Also See for GRAND VITARA 2005:
- Owner's manual (1736 pages) ,
- Service manual (801 pages) ,
- Manual (35 pages)
Table of Contents
10C-21 Immobilizer Control System:
Registration of the Ignition Key
To finish the registration of the ignition key, the
transponder code memorized in the transponder built in
the ignition key has to be registered with ICM. To register
the transponder code with ICM, perform "Register Ig
Key" mode of SUZUKI scan tool referring to "SUZUKI
Tech 2 Operator's Manual".
NOTE
• A maximum of four transponder codes can
be registered with ICM.
• At an early part of the registration process,
all transponder codes of the ignition keys
in use already registered with ICM are
cleared. Therefore, before starting the
registration, prepare all ignition keys in
use in addition to the new ignition key(s) to
be registered with ICM.
Special Tool
SUZUKI scan tool
—
This kit includes following
items. 1. Tech 2, 2. PCMCIA
card, 3. DLC cable, 4. SAE
16/19 adapter, 5. Cigarette
cable, 6. DLC loopback
adapter, 7. Battery power
cable, 8. RS232 cable, 9.
RS232 adapter, 10. RS232
loop back connector, 11.
Storage case, 12. Power
supply
/
Procedure after ECM Replacement
S5JB0BA306002
After ECM is replaced with new one or used one, the key
verification code stored in the ECM has to be registered
with immobilizer control system. To register key
verification code stored in the ECM with immobilizer
control system, perform "Replace ECM" mode of
SUZUKI scan tool referring to "SUZUKI Tech 2
Operator's Manual".
Procedure after Immobilizer Control Module
(ICM) Replacement
After ICM replaced with new one or used one,
transponder code memorized in the transponder built in
the ignition key in use has to be registered with ICM and
then, key verification code stored in the ICM has to be
registered with immobilizer control system. To register
ignition key in use with ICM and to register verification
code stored in the ICM with immobilizer control system,
perform "Replace Immobilizer Module" mode of SUZUKI
scan tool referring to "SUZUKI Tech 2 Operator's
Manual".
Special Tools and Equipment
NOTE
• A maximum of four transponder codes can
be registered with ICM.
• At an early part of the registration process,
all transponder codes of the ignition keys
in use already registered with ICM are
cleared. Therefore, before starting the
registration, prepare all ignition keys in
use in addition to the new ignition key(s) to
be registered with ICM.
S5JB0BA306003
S5JB0BA306004
S5JB0BA308001
Chapters
Table of Contents
