Suzuki GRAND VITARA 2005 Service Manual page 358

Hide thumbs Also See for GRAND VITARA 2005:
Table of Contents
4E-16 ABS:
Troubleshooting
Step
1
1) Make sure that:
• Parking brake is completely released.
• Brake fluid level is upper than the minimum level.
Are the check results OK?
2
1) Turn ignition switch to ON position.
Does ABS warning lamp come on steady?
3
1) CAN communication circuit between combination meter,
ABS hydraulic unit / control module and BCM referring to
"DTC U1073: Control Module Communication Bus Off: ".
Is CAN communication circuit in good condition?
DTC C1015: G Sensor Circuit Failure (For 4WD Vehicle)
For vehicle equipped with ESP®, go to "DTC C1015 / C1017 / C1023: Longitudinal G Sensor / Lateral G Sensor / Yaw
Rate Sensor in Yaw Rate / G Sensor Assembly Failure: in Section 4F".
Description
If the signal voltage of G sensor while at a stop does not vary of from that while running, this DTC is set.
Therefore, this DTC may be set when a vehicle is lifted up and its wheel(s) is turned. In such case, clear the DTC and
check again.
DTC Troubleshooting
1) Ignition switch OFF.
2) Check for proper connection from harness to control module.
3) If OK, substitute an ABS hydraulic unit/control module assembly with correct part number.
4) Recheck system.
Action
Yes
Go to Step 2.
Perform "ABS Warning
Lamp Comes ON
Steady: " previously
outlined.
Substitute a known-
good combination meter
and recheck. If ABS
warning lamp remains
ON, substitute a known-
good ABS (ESP®)
hydraulic unit / control
module assembly and
recheck.
No
Release parking brake
completely and/or
replenish brake fluid.
Go to Step 3.
Repair or replace.
S5JB0B4504013
Table of Contents
loading

Table of Contents