Suzuki GRAND VITARA 2005 Service Manual page 329
Hide thumbs
Also See for GRAND VITARA 2005:
- Owner's manual (1736 pages) ,
- Service manual (801 pages) ,
- Manual (35 pages)
Table of Contents
10) Install thrust needle bearing (4), front drive shaft (1)
and needle bearings (2) to rear output shaft (3).
3
4
11) Install low gear (3), center differential (4) and
reduction shift sleeve (1) to rear output shaft (2).
4
[A]
3
[A]: Rear case side
1
2
1
I5JB0A331041-02
1
2
4
I5JB0A331042-02
12) Select shim (1) as follows.
a) Install shim, washer (2) and used snap ring (3)
into rear output shaft (4).
b) Check clearance between shim and washer.
c) If clearance is out of specified value, select shim
from the following table so that clearance
become specified value.
Clearance between shim and washer
: 0.1 – 0.3 mm (0.004 – 0.012 in.)
Available shim thickness
0.4 mm (0.016 in.)
0.6 mm (0.024 in.)
0.8 mm (0.031 in.)
1.0 mm (0.039 in.)
1.2 mm (0.047 in.)
1.4 mm (0.055 in.)
2
13) Remove used snap ring, and then install new snap
ring (2) and needle bearing (1) to rear output shaft
(3).
3
Transfer:
3C-18
1.6 mm (0.063 in.)
1.8 mm (0.071 in.)
2.0 mm (0.079 in.)
2.2 mm (0.087 in.)
2.4 mm (0.098 in.)
4
3
1
I5JB0A331043-01
1
2
I5JB0A331044-02
Chapters
Table of Contents
