Siemens SINAMICS S210 Operating Instructions Manual page 535
Servo drive system, converter,
servomotor
Hide thumbs
Also See for SINAMICS S210:
- Operating instructions manual (769 pages) ,
- Operating instructions manual (6 pages)
Table of Contents
Cause:
An internal software error has occurred in the Sensor Module of encoder 1.
Fault value (r0949, interpret decimal):
1: Background time slice is blocked.
2: Checksum over the code memory is not OK.
10000: OEM memory of the EnDat encoder contains data that cannot be interpreted.
11000 ... 11499: Descriptive data from EEPROM incorrect.
11500 ... 11899: Calibration data from EEPROM incorrect.
11900 ... 11999: Configuration data from EEPROM incorrect.
12000 ... 12008: communication with analog/digital converter faulted.
16000: DRIVE-CLiQ encoder initialization application error.
16001: DRIVE-CLiQ encoder initialization ALU error.
16002: DRIVE-CLiQ encoder HISI / SISI initialization error.
16003: DRIVE-CLiQ encoder safety initialization error.
16004: DRIVE-CLiQ encoder internal system error.
Remedy:
- replace the Sensor Module.
- if required, upgrade the firmware in the Sensor Module.
- contact Technical Support.
F31851
Encoder 1 DRIVE-CLiQ (CU): Sign-of-life missing
Reaction:
ENCODER
Acknowledge:
IMMEDIATELY
Cause:
A DRIVE-CLiQ communication error has occurred from the Sensor Module (encoder 1) involved to the Control Unit.
The DRIVE-CLiQ component did not set the sign-of-life to the Control Unit.
Fault cause:
10 (= 0A hex):
The sign-of-life bit in the receive telegram is not set.
Note regarding the message value:
The individual information is coded as follows in the message value (r0949/r2124):
0000yyxx hex: yy = component number, xx = error cause
Remedy:
- Upgrade the firmware of the component involved.
- carry out a POWER ON (switch-off/switch-on) for the component involved.
F31860
Encoder 1 DRIVE-CLiQ (CU): Telegram error
Reaction:
ENCODER
Acknowledge:
IMMEDIATELY
SINAMICS S210 servo drive system
Operating Instructions, 01/2019, A5E41702836B AC
Faults and alarms
15.2 List of faults and alarms
533
- Quick Links:
- Faults
- List of Faults and Alarms
Hide quick links:
Table of Contents
