Dynojet POWER COMMANDER V Installation Instructions
2013 kawasaki z800
Hide thumbs
Also See for POWER COMMANDER V:
- Installation manual (9 pages) ,
- Installation instructions manual (9 pages) ,
- Installation instructions and owner's manuals (8 pages)
Quick Links
2013 Kawasaki Z800
I n s t a l l a t i o n I n s t r u c t i o n s
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
I17-048
www.powercommander.com
2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
PARTS LIST
1
Power Commander
1
USB Cable
1
CD-ROM
1
Installation Guide
2
Power Commander Decals
2
Dynojet Decals
2
Velcro Strip
1
Alcohol Swab
1
O2 Optimizer
THE IGNITION MUST BE TURNED
OFF BEFORE INSTALLATION!
YOU CAN ALSO DOWNLOAD THE
POWER COMMANDER SOFTWARE AND
LATEST MAPS FROM OUR WEB SITE AT:
www.powercommander.com
2013 Kawasaki Z800 - PCV - 1
Related Manuals for Dynojet POWER COMMANDER V
Summary of Contents for Dynojet POWER COMMANDER V
- Page 1 2013 Kawasaki Z800 Installation Guide Power Commander Decals I n s t a l l a t i o n I n s t r u c t i o n s Dynojet Decals Velcro Strip Alcohol Swab O2 Optimizer...
- Page 2 Do NOT connect anything to this port unless wire into the hole of the PCV until is stops and then instructed to do so by Dynojet. It is used to tighten the screw. Make sure to reinstall the rubber transfer crank trigger data from one module to plug.
- Page 3 FIG.A The installation can be done without removing the fuel tank but it may make the installation easier by doing so. Remove the main seat and the passenger seat. Mount the PCV to the inner rear fender near the battery and fuse box (Fig. A). Attach the ground wire of the PCV to the common ground wire location Ground (Fig.
- Page 4 This is the 4 pin BLACK connector at the top of the row of connectors FIG.F Optimizer Plug the Dynojet O2 Optimizer in-line of the stock O2 sensor and wiring harness (Fig. F). Tuck the Optimizer behind the bracket shown in Figure. F.