Dynojet Power Commander V Installation Instructions Manual
  1. Manuals
  2. Brands
  3. Dynojet Manuals
  4. Motorcycle Accessories
  5. Power commander V
  6. Installation instructions manual
Dynojet Power Commander V Installation Instructions Manual

Dynojet Power Commander V Installation Instructions Manual

For yamaha vector 2010; yamaha vector 2011 snowmobile motorcycle fuel injection tuning module
Hide thumbs Also See for Power Commander V:
1
2
3
4
5
6
7

Quick Links

See also: Installation Instructions & Owner's Manual, Instruction and Installation Manual
2010-2011 Yamaha Vector
Snowmobile
Installation Instructions
P
LEASE
I22-039.01
R
A
D
EAD
LL
IRECTIONS
2191 Mendenhall Drive • North Las Vegas, NV 89081 • (800) 992-4993 • www.powercommander.com
quantity
1
1
1
1
2
2
2
1
The ignition MUST be turned
OFF before installation!
D
OWNLOAD THE
AND LATEST MAPS FROM OUR WEBSITE
B
S
I
EFORE
TARTING
NSTALLATION
P
L
ARTS
IST
description
power commander
USB cable
cd-rom
installation guide
power commander decals
dynojet decals
velcro strip
alcohol swab
P
C
OWER
OMMANDER SOFTWARE
:
.
.
WWW
POWERCOMMANDER
COM
2010-2011 Yamaha Vector - PCV - 1
loading

Related Manuals for Dynojet Power Commander V

Summary of Contents for Dynojet Power Commander V

  • Page 1 2010-2011 Yamaha Vector USB cable cd-rom Snowmobile installation guide power commander decals Installation Instructions dynojet decals velcro strip alcohol swab The ignition MUST be turned OFF before installation! OWNLOAD THE OWER OMMANDER SOFTWARE AND LATEST MAPS FROM OUR WEBSITE...

  • Page 2: Accessory Inputs

    Crank - 3. Push the wire into the hole of the PCV until it instructed to do so by Dynojet. It is used to stops and then tighten the screw. transfer crank trigger data from one module to 4.
  • Page 3 The ignition must be turned OFF before installation. Loosen the cam screws located near the headlight/windshield assembly as shown in Figure A. Remove the front body panel. cam screw cam screw Remove the right and left side body panels by loosening the cam screws as shown in Figure B.
  • Page 4 With the headlight/windshield assembly moved forward, unplug the two connectors on the gauge harness. This will allow you to completely remove the headlight/windshield assembly. unplug connectors Remove the headlight/windshield assembly. Remove the four bolts securing the upper frame brace. Only two bolts are visible in Figure E.
  • Page 5 11 Disconnect the two hoses on the MAG side of the airbox as shown in Figure G. 12 Disconnect the sensor connector on the PTO side of the airbox as shown in Figure G. 13 Using a ball head allen wrench, loosen the three clamps securing the airbox to the throttle bodies.
  • Page 6 21 Using the supplied velcro, secure the PCV to the clutch cover as shown in Figure J. Make sure to clean both surfaces with the alcohol swab before attaching. attach ring lug 22 Bolt the ring lug to the frame when the upper frame brace is replaced. 23 Replace the airbox.
  • Page 7 If you are looking for a display for your setup we have the answer. Dynojet’s LCD-200 is a color touch screen display capable of displaying all PC data and AFR if you are using the Wideband 2.