Dynojet POWER COMMANDER V Installation Instructions
  1. Manuals
  2. Brands
  3. Dynojet Manuals
  4. Automobile Accessories
  5. Power commander V
  6. Installation instructions

Dynojet POWER COMMANDER V Installation Instructions

2002-2003 yamaha r1
Hide thumbs Also See for POWER COMMANDER V:
1
2
3
4

Quick Links

See also: Installation Instructions & Owner's Manual, Instruction and Installation Manual
2002-2003 Yamaha R1
I n s t a l l a t i o n I n s t r u c t i o n s
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
22-059
www.powercommander.com
2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
PARTS LIST
1
Power Commander
1
USB Cable
1
Installation Guide
2
Power Commander Decals
2
Dynojet Decals
2
Velcro strips
1
Alcohol swab
THE IGNITION MUST BE TURNED
OFF BEFORE INSTALLATION!
THE LATEST POWER COMMANDER
SOFTWARE AND MAP FILES CAN BE
DOWNLOADED FROM OUR WEB SITE AT:
www.powercommander.com
2002-2003 Yamaha R1 - PCV - 1
loading

Related Manuals for Dynojet POWER COMMANDER V

Summary of Contents for Dynojet POWER COMMANDER V

  • Page 1 Power Commander USB Cable Installation Guide 2002-2003 Yamaha R1 Power Commander Decals Dynojet Decals I n s t a l l a t i o n I n s t r u c t i o n s Velcro strips Alcohol swab THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION!
  • Page 2 Crank- Do NOT connect anything to this port unless plug. instructed to do so by Dynojet. It is used to transfer crank trigger data from one module to NOTE: If you tin the wires with solder it will make another.
  • Page 3 FIG.A Remove the rider’s and passenger’s seat (or solo cover). Lift the front of the fuel tank and prop it up with a prop rod. Unplug Locate and unplug the stock 6-pin and 4-pin connectors for the bike’s fuel injector sub-harness and throttle position sensor (Fig. A). Unplug These connectors are located behind the throttle bodies under the fuel tank on the left hand side of the bike. FIG.B Plug the pair of 6-pin connectors on the PCV wiring harness in-line of the stock 6-pin connectors (Fig. B). FIG.C Plug the pair of 4-pin connectors on the PCV wiring harness in-line of the stock 4-pin connectors (Fig. C). 22-059 www.powercommander.com 2002-2003 Yamaha R1 - PCV - 3...
  • Page 4 FIG.D Route the PCV wiring harness to the tail section following just inside the left PCV Harness side frame rail. Ground Secure the PCV ground wire with the ring lug to the negative (-) side of the bike’s battery (Fig. D). Secure the PCV module inside the tail section, using the supplied Velcro FIG.E (Fig. E). Clean the surface with the supplied alcohol swab prior to applying the Velcro. Lower and secure the fuel tank. 10 Reinstall the seats. Optional inputs: Speed - PINK wire from speed sensor. Connector is located under the fuel tank on the right hand side. Connector has PINK, ORANGE/RED, and BLACK/ WHITE wires. Temperature - GREEN/WHITE wire on pin #31 of the ECU 12v source for Auto-tune - BLUE wire of taillight connector. Connector is located by the ECU. It is a WHITE 3-pin connector with BLACK, BLUE, and YELLOW wires.