Dynojet POWER COMMANDER V Installation Manual
2020 yamaha mt-03
Hide thumbs
Also See for POWER COMMANDER V:
- Installation instructions manual (9 pages) ,
- Installation manual (9 pages) ,
- Installation instructions and owner's manuals (8 pages)
Related Manuals for Dynojet POWER COMMANDER V
Summary of Contents for Dynojet POWER COMMANDER V
- Page 1 POWER COMMANDER V 2020 Yamaha MT-03 Installation Guide PARTS LIST POWER COMMANDER V DYNOJET DECALS INSTALLATION GUIDE POWER COMMANDER DECALS USB CABLE ALCOHOL SWAB VELCRO STRIPS PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION 17-082...
-
Page 2: Usb Connection
Crank- Do NOT connect anything to this port unless instructed to do so by Dynojet. It is used to transfer crank trigger data from one module to another. WIRE CONNECTIONS: To input wires into the PCV first remove the rubber plug on the backside of the unit and loosen the screw for the corresponding input. - Page 3 INSTALLING THE POWER COMMANDER V Remove the seats, the fuel tank shell, the side panels below the fuel tank, and the fuel tank. Loosen the coolant reserve bottle. REMOVE COOLANT RESERVE BOTTLE Remove the bolts that hold the ignition coils in place.
- Page 4 INSTALLING THE POWER COMMANDER V Unplug the stock harness from the fuel injectors. UNPLUG UNPLUG UNPLUG THE FUEL INJECTORS Plug the PCV in-line of the stock injectors and wiring harness PCV Orange wires - left, Grey stock connector PCV Yellow wires - right, Brown stock connector...
- Page 5 INSTALLING THE POWER COMMANDER V Unplug the crank position sensor connector. This is a BLACK connector pair on the left side of the motorcycle. UNPLUG THE CPS Plug the PCV in-line of the CPS and wiring harness. CONNECT TO THE CPS Secure the PCV in the tail section using the supplied Velcro.
- Page 6 2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.COM © 2019 DYNOJET RESEARCH ALL RIGHTS RESERVED...