Dynojet POWER COMMANDER V Installation Manual
2019 bmw f850gs
Hide thumbs
Also See for POWER COMMANDER V:
- Installation instructions manual (9 pages) ,
- Installation manual (9 pages) ,
- Installation instructions and owner's manuals (8 pages)
Related Manuals for Dynojet POWER COMMANDER V
Summary of Contents for Dynojet POWER COMMANDER V
- Page 1 POWER COMMANDER V 2019 BMW F850GS Installation Guide PARTS LIST POWER COMMANDER V DYNOJET DECALS INSTALLATION GUIDE POWER COMMANDER DECALS USB CABLE ALCOHOL SWAB VELCRO STRIPS POSI-TAP PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION 12-026...
-
Page 2: Usb Connection
Crank- Do NOT connect anything to this port unless instructed to do so by Dynojet. It is used to transfer crank trigger data from one module to another. WIRE CONNECTIONS: To input wires into the PCV first remove the rubber plug on the backside of the unit and loosen the screw for the corresponding input. - Page 3 INSTALLING THE POWER COMMANDER V Remove the seat. Remove the bodywork around the fuel tank. Remove the fuel tank. Remove the airbox. Secure the PCV module in the tail section under the seat. Use the supplied Velcro strips to secure the module.
-
Page 4: Fuel Injectors
INSTALLING THE POWER COMMANDER V Unplug both of the Fuel Injectors. FUEL INJECTORS Route the PCV wiring harness between the mouths of the throttle bodies and beneath the fuel rail. Plug the pair of PCV connectors with ORANGE colored wires in-line of the LEFT Fuel Injector and its stock connector. - Page 5 INSTALLING THE POWER COMMANDER V Plug the PCV connectors with BROWN colored wires in-line of the Crank Position Sensor and its stock connector. Reinstall the airbox, fuel tank, bodywork, and the seat. PCV CONNECTED TO CRANK POSITION SENSOR 12-026...
- Page 6 2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.COM © 2019 DYNOJET RESEARCH ALL RIGHTS RESERVED...