Dynojet Power Commander V Installation Instructions
For 2009 yamaha r6s
Hide thumbs
Also See for Power Commander V:
- Installation instructions manual (9 pages) ,
- Installation manual (9 pages) ,
- Installation instructions and owner's manuals (8 pages)
Quick Links
2009 Yamaha R6S
I n s t a l l a t i o n I n s t r u c t i o n s
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
22-001 www.powercommander.com
2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
PARTS LIST
1
Power Commander
1
USB Cable
1
CD-ROM
1
Installation Guide
2
Power Commander Decals
2
Dynojet Decals
2
Velcro
1
Alcohol swab
THE IGNITION MUST BE TURNED
OFF BEFORE INSTALLATION!
YOU CAN ALSO DOWNLOAD THE
POWER COMMANDER SOFTWARE AND
LATEST MAPS FROM OUR WEB SITE AT:
www.powercommander.com
2009 Yamaha R6S PCV - 1
Related Manuals for Dynojet Power Commander V
Summary of Contents for Dynojet Power Commander V
- Page 1 CD-ROM I n s t a l l a t i o n I n s t r u c t i o n s Installation Guide Power Commander Decals Dynojet Decals Velcro Alcohol swab THE IGNITION MUST BE TURNED...
- Page 2 Crank- wire into the hole of the PCV until is stops and then instructed to do so by Dynojet. It is used to tighten the screw. Make sure to reinstall the rubber transfer crank trigger data from one module to plug.
- Page 3 FIG.A Remove the main seat and the passenger seat. Prop the front of fuel tank up. Remove the rubber plug in the tail section near the tool kit. Lay the PCV unit in the tail section and route the harness thru the hole and down the right side of the bike (Fig.
- Page 4 FIG.D Plug the PCV connectors in-line of the throttle bodies and main wiring harness (Fig. D). Plug the colored connectors from the PCV into the matching stock connectors. FIG.E Secure the PCV unit in the tail section using the supplied velcro (Fig. E). Make sure to clean both surfaces with the alcohol swab before attaching Bolt the fuel tank back into place and reinstall the seats.