Dynojet Power Commander V Installation Instructions
For husqvarna te630 2011
Hide thumbs
Also See for Power Commander V:
- Installation instructions manual (9 pages) ,
- Installation manual (9 pages) ,
- Installation instructions and owner's manuals (8 pages)
Quick Links
2011 Husqvarna TE630
I n s t a l l a t i o n I n s t r u c t i o n s
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
23-008
www.powercommander.com
2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
PARTS LIST
1
Power Commander
1
USB Cable
1
CD-ROM
1
Installation Guide
2
Power Commander Decals
2
Dynojet Decals
2
Velcro
1
Alcohol swab
1
O2 Optimizer
1
Posi-Tap
THE IGNITION MUST BE TURNED
OFF BEFORE INSTALLATION!
YOU CAN ALSO DOWNLOAD THE
POWER COMMANDER SOFTWARE AND
LATEST MAPS FROM OUR WEB SITE AT:
www.powercommander.com
2011 Husqvarna TE630 PCV - 1
Related Manuals for Dynojet Power Commander V
Summary of Contents for Dynojet Power Commander V
- Page 1 CD-ROM Installation Guide 2011 Husqvarna TE630 Power Commander Decals I n s t a l l a t i o n I n s t r u c t i o n s Dynojet Decals Velcro Alcohol swab O2 Optimizer Posi-Tap THE IGNITION MUST BE TURNED...
- Page 2 POWER COMMANDER V INPUT ACCESSORY GUIDE ACCESSORY INPUTS Map - The PCV has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use USB CONNECTION any open/close type switch. The polarity of the wires is not important. When using the Autotune kit one position will hold a base map and the other position will let you activate the learning mode. When the switch is “CLOSED” Autotune will be activated. These inputs are for use with the Dynojet Shifter- quickshifter. Insert the wires from the Dynojet quickshifter into the SHIFTER inputs. The CRANK polarity of the wires is not important. ANALOG Speed- If your application has a speed sensor then SPEED you can tap into the signal side of the sensor EXPANSION PORTS 1 & 2 SHIFTER and run a wire into this input. This will allow...
- Page 3 FIG.A Remove the seat. Remove the fuel tank. Using the supplied velcro attach the PCV to the inner side of the right hand side cover (Fig. A). Make sure to clean both surfaces with the alcohol swab before attaching. FIG.B Attach the ground wire from the PCV to the negative side of the battery (Fig. B). Ground wire FIG.C Route the PCV harness towards the throttle body going underneath the frame support. Unplug the stock wiring harness from the injector (Fig. C). 23-008 www.powercommander.com 2011 Husqvarna TE630 PCV - 3...
- Page 4 This is the 3rd wire from the end, on the top row of the ECU. FIG.F Locate the stock O2 sensor connection. This is under the fuel tank on the left hand side of the frame (Fig. F). 10 Unplug this connection and install the Dynojet O2 eliminator onto the stock wiring harness. The O2 sensor will not be connected to anything at this time. It can be removed from the exhaust if desired. 11 Reinstall the fuel tank and seat.