Exiting Programming Mode - Honeywell AlarmNet 7845i-GSM Installation And Setup Manual
Internet communication
Hide thumbs
Also See for AlarmNet 7845i-GSM:
- Quick setup manual (1 page) ,
- Installation manual (2 pages) ,
- Quick manual (2 pages)
Table of Contents
PROMPTS
NIC IP Address:
69
255.255.255.255_
Subnet Mask:
70
255.255.255.255_
Gateway IP Addr:
71
255.255.255.255_
DNS Serv IP Addr:
72
255.255.255.255_
Review? Y/N
73
Exiting Programming Mode
To exit the programming mode, press [N] in response to the "REVIEW?" question. Then press
[Y] to the "Exit Prog Mode?" question. Upon exiting, the root file is updated to log the
changes made. A message is displayed telling the user that this step is being executed. When
complete, the message "DONE" is displayed to indicate the file was successfully uploaded.
If critical configuration changes were made, such as the mode of operation, the 7845i-GSM
will reset to ensure that the programming features are enabled.
If the file is not successfully uploaded, one of the following prompts will be displayed. Follow
the steps shown below until the upload is successful.
Display
Cannot Upload
Try Again? Y/N_
Failed to Update
Root File!
4204/
ZONE
ENTRY
2-4204
TRIG.
✔
✔
12 digit:
xxx.xxx.xxx.xxx
✔
✔
12 digit:
xxx.xxx.xxx.xxx
✔
✔
12 digit:
xxx.xxx.xxx.xxx
[0.0.0.0.] = not
used
12 digit:
✔
✔
xxx.xxx.xxx.xxx
[0.0.0.0.] = not
used
✔
✔
[Y] = review
[N] = exit
Description
GSM radio not yet initialized.
Network problem, or you
answered "N" to "Cannot Upload
Try Again?" prompt.
Section 3: Programming the 7845i-GSM
OPTIONS
Enter the 4-part address for this device. The 4
parts of the address must be separated by spaces
(displayed as periods in Review mode).
Enter the 32-bit address mask used to indicate
the portion (bits) of the IP address that is being
used for the subnet address. The 4 parts of the
address must be separated by spaces (displayed
as periods in Review mode).
Enter the 4-part address assigned to the
Gateway. The 4 parts of the address must be
separated by spaces (displayed as periods in
Review mode).
Enter the 4-part IP address assigned to the DNS
(Domain Name System) server. The 4 parts of
the address must be separated by spaces
(displayed as periods in Review mode).
Reviewing Programming Mode Entries
To review the programming options (to ensure
that the correct entries have been made), press
[Y]. The programming questions are displayed
again. Use the up/down arrow keys to scroll
through the program fields without changing
any of the values. If a value requires change,
simply type in the correct value. When the last
field is displayed, the "REVIEW?" question again
appears.
To exit the programming mode, press [N] in
response to the "REVIEW?" question, and refer
to Exiting Programming Mode below.
What to do
Wait for RSSI LEDs to be lit.
Press [Y].
Initiate the Force Server Update
Command by pressing the [0] key; refer
to Section 5: Programmer Keyboard
Commands.
DESCRIPTION
3-17
Hide quick links:
Table of Contents
