Programming Conventions; Ecp Mode Programming - Honeywell AlarmNet 7845i-GSM Installation And Setup Manual
Internet communication
Hide thumbs
Also See for AlarmNet 7845i-GSM:
- Quick setup manual (1 page) ,
- Installation manual (2 pages) ,
- Quick manual (2 pages)
Table of Contents
Internet Communication Module 7845i-GSM Installation and Setup Guide
KEY
5/E
6/F
7/S
8/T
9/X
SPACE
0
#/ENTER
Programming Conventions
Programming is accomplished by answering a series of prompts (questions). Most prompts
require only a [Y]es or [N]o response, while others require a numerical response (ID
numbers, etc.).
The current value is displayed on the second line in parentheses ( ). A "?" indicates an
invalid entry.
Use the [ENTER] key to accept the current entry and proceed to the next prompt. If the
entered value is invalid, pressing [ENTER] re-displays the prompt; the next prompt is not
displayed until a valid answer is entered.
Use the up/down arrow keys to scroll through the programming questions without changing
any values. Press the [ESC] key to go to the end of the list of questions.
ECP Mode Programming
The 7845i-GSM supports ECP messaging to communicate with the control panel. LRR-
enabled control panels send Contact ID format alarms to the 7845i-GSM directly on the 4-
wire console bus. Not all control panels support the LRR interface on ECP, so be sure to
check the Installation and Setup Guide of the control panel to see if it supports this feature.
Press the [ENTER] key to begin programming.
NOTE: The central station can remotely block access to local
NOTE: The default programming values for ECP mode are listed in each prompt below.
PROMPTS
Strt Prog Mode?
1
(Y/N)_
Enter Password:
2
Program 7845?
3
(Y/N)_
3-2
NORMAL KEY FUNCTION
[5]: For entering the number 5
[6]: For entering the number 6
[7]: For entering the number 7
[8]: For entering the number 8
[9]: For entering the number 9
[SPACE]: For scrolling option list
[0]: For entering the number 0
[#/ENTER]: Starts programming mode;
Press to accept entries
device programming. If this has been done, the
following prompt appears:
Table 3: Programming a 7845i-GSM for ECP mode only.
ENTRY
OPTIONS
[Y], [N]
[0-9, A-F, N, S,
T, X, Y]
[Y], [N ]
SHIFT KEY FUNCTION
[E]: For entering letter E
[F]: For entering letter F
[S]: For entering letter S
[T]: For entering letter T
[X]: For entering letter X
No SHIFT function
No SHIFT function
No SHIFT function
Access to Prog
Mode Denied
DESCRIPTION
Enters programming mode.
If a password has been previously assigned, this
prompt appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
The next prompt appears.
To begin programming the module, press [Y] and go
to Prompt 9: "Device Mode."
To create a password if none has been assigned, press
[N] and go to Prompt 4: "Create Password."
To change an existing password, press [N] and go to
Prompt 5: "Change Password."
Hide quick links:
Table of Contents
