Ecp Status Codes - Honeywell AlarmNet 7845i-GSM Installation And Setup Manual

PROMPTS

Gateway IP Addr:

44

255.255.255.255_

DNS Serv IP Addr:

45

255.255.255.255_

Review? Y/N

46

When the 7845i-GSM is configured for ECP mode, it sends status messages to the control

panels for battery, power, tamper, and network connectivity failures. Some of the control

panels (e.g., VISTA-10P, VISTA-15P and VISTA-20P Series) display these on the keypad as

"LngRng Radio" followed by a 4-digit code (listed in Table 4). In addition, the Contact ID

codes (listed in Appendix A) for these conditions are sent to the central station by the

module.

STATUS CODE

0000

0880

4005

000F

0019

0400

0C80

0C8F

08E0

3000

8000

0060

ENTRY

OPTIONS

12 digit:

xxx.xxx.xxx.xxx

[0.0.0.0.] = not

used

12 digit:

xxx.xxx.xxx.xxx

[0.0.0.0.] = not

used

[Y] = review

[N] = exit

Table 4. Common ECP Keypad Display Status Codes

Control panel lost communication with 7845i-GSM.

7845i-GSM tamper detected (cover removed).

7845i-GSM has lost contact with AlarmNet.

7845i-GSM is not registered; account not activated.

7845i-GSM shutdown.

7845i-GSM power-on reset AND the control panel lost communications with

7845i-GSM.

7845i-GSM power on reset AND tamper detected.

7845i-GSM power on reset AND tamper detected AND not registered.

7845i-GSM tamper detected and 7845i-GSM battery low.

Primary power loss (will only be displayed in conjunction with another event).

Battery charger failure (will only be displayed in conjunction with another

event).

Low battery (will only be displayed in conjunction with another event).

Section 3: Programming the 7845i-GSM

DESCRIPTION

Enter the 4-part address assigned to the Gateway. The

4 parts of the address must be separated by spaces

(displayed as periods in Review mode).

Enter the 4-part IP address assigned to the DNS

(Domain Name System) server. The 4 parts of the

address must be separated by spaces (displayed as

periods in Review mode).

Reviewing Programming Mode Entries

To review the programming options (to ensure that the

correct entries have been made), press [Y]. The

programming prompts are displayed again. Use the

up/down arrow keys to scroll through the program

fields without changing any of the values. If a value

requires change, simply type in the correct value. When

the last field is displayed, the "REVIEW?" prompt

again appears.

To exit the programming mode, press [N] in

response to the "REVIEW?" prompt, and refer to

Exiting Programming Mode at the end of this section.

DESCRIPTION

3-7