Section 3: Programming The 7845I Gsm; General Information; Using A 7720P Programming Tool - Honeywell AlarmNet 7845i-GSM Installation And Setup Manual
Internet communication
Hide thumbs
Also See for AlarmNet 7845i-GSM:
- Quick setup manual (1 page) ,
- Installation manual (2 pages) ,
- Quick manual (2 pages)
Table of Contents
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
o
General Information
o
ECP Mode Programming
o
Alternative Modes (Zone Trigger, 4204 and
Two-4204)
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
General Information
The 7845i-GSM is designed to deliver alarms via the Internet to an AlarmNet central station
or via the AlarmNet-G network, using GSM (Global System for Mobile) technology when the
Internet is not available.
The 7845i-GSM uses 256 bit AES (Rijndael) encryption which is required for certain
government installations.
You can program a 7845i-GSM by one of the following methods:
• Through use of a 7720P Programming Tool
• Through a programming mode in the control panel, on panels that support this option
(e.g., VISTA-128BP and FBP)
Using a 7720P Programming Tool
Connect the 7720P Programming Tool; refer to Figure 8 in Section 2. The 7845i-GSM powers
the 7720P Programming Tool via the programming jack, and automatically senses the
presence of the 7720P when it is plugged in.
Each key of the 7720P has two possible functions: a normal function and a Shift function.
To perform a normal key function, simply press the desired key.
To perform a Shift function, press the [shift] key, and then press the appropriate key.
The prompts in this document reflect use of the 7720P Programming Tool. Table 2 below lists
each normal and shift key function.
KEY
BS/ESC
↓/↑
N/Y
SHIFT
1/A
2/B
3/C
4/D
* Active only when the "Exit Programming Mode" prompt is displayed.
Programming the 7845i-GSM
Table 2. 7720P Normal and Shift Key (shift LED lit) Functions
NORMAL KEY FUNCTION
[BS]: Press to delete entry
[↓]: Scroll down programming
[N]: Press for "NO" answer
Press before pressing a SHIFT key function. Will light SHIFT LED. LED goes out once a key
is pressed. Press again for each SHIFT function desired.
[1]: For entering the number 1
[2]: For entering the number 2
[3]: For entering the number 3
[4]: For entering the number 4
o
Alternative Mode Programming
o
Exiting Programming Mode
SHIFT KEY FUNCTION
[ESC]: Press to quit program mode; also can reset
programming defaults*
[↑]: Scroll up programming
[Y]: Press SHIFT-Y for "YES" answer
[A]: For entering letter A
[B]: For entering letter B
[C]: For entering letter C
[D]: For entering letter D
S E C T I O N
3
3-1
Hide quick links:
Table of Contents
