System Status Displays - Honeywell AlarmNet 7845i-GSM Installation And Setup Manual
Internet communication
Hide thumbs
Also See for AlarmNet 7845i-GSM:
- Quick setup manual (1 page) ,
- Installation manual (2 pages) ,
- Quick manual (2 pages)
Table of Contents
Cntry Netw LAC
xxx xxx xxxxx
Cell BaseSt Chan
xxxxx
Second Site RSSI
-xxxdbm
[F]
Testing Gateway
Redir 1
System Status Displays
[S]
ECP 67 TmPB
1234 67 TmPB Flt
5555 xx 5 ++ OK
12345678 TmPB Flt
5555555x 5 ++ OK
1234567 TmPB Flt
5555555 5 ++ OK
GSM Status Display Screen 2
Cntry – Country Code
Netw – Network Code
LAC – Local area code
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
GSM Status Display Screen 3
x
xxx
Cell – Base Station ID
BaseSt – Base Station Antenna Sector
Chan – Control Channel in use
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the previous field.
GSM Status Display Screen 4
Secondary GSM Site RSSI level in dBm.
Press the [space] key to go to the GSM Status Display
Screen 1.
Press the [backspace] key to go to the previous field.
Run Network Diagnostic Test
Performs a set of network diagnostics that tests the
integrity of the links between the 7845i-GSM and the
various connection points (Redirs) to AlarmNet. Refer
to Section 6: Network Diagnostics.
ECP Mode
Flt
xx 5 ++
OK
Displays the zone and system fault status.
Press the [space] key to go to the next field.
Press the [backspace] key to go to the previous field.
4204 Emulation Mode
Displays the zone and system fault status.
Press the [space] key to go to the next field.
Press the [backspace] key to go to the previous field.
Two-4204 Emulation Mode
Displays the zone and system fault status.
Press the [space] key to go to the next field.
Press the [backspace] key to go to the previous field.
Zone Trigger Mode
The status of the 7845i-GSM can be viewed on the
7720P. The status display includes:
Section 5: Programmer Keyboard Commands
•
Zone input status (1234567) - the
numbers 1-7 represent the 7 mappings of
the zone input, and follow Honeywell's
ADEMCO high-speed format codes:
1 = New Event
5-3
Hide quick links:
Table of Contents
