Honeywell AlarmNet 7845i-GSM Installation And Setup Manual page 26
Internet communication
Hide thumbs
Also See for AlarmNet 7845i-GSM:
- Quick setup manual (1 page) ,
- Installation manual (2 pages) ,
- Quick manual (2 pages)
Table of Contents
Internet Communication Module 7845i-GSM Installation and Setup Guide
PROMPTS
Verify Password
7
Exit Prog. Mode?
8
Y/N_
Device Mode
9
(ECP)_
Important Information Regarding Primary Account (Questions 10-12)
Account information is provided by the central station administrator.
Primary City ID
10
(??)_
Primary CS ID
11
(???)
Primary Sub ID
12
(????)
Device Address
13
(12)_
Enable DW Y/N
14
(N)_
3-10
4204/
ZONE
ENTRY
2-4204
TRIG.
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
✔
OPTIONS
Re-enter the password as confirmation.
[0-9, A-F, N,
If the password doesn't match the first entry, the
S, T, X, Y]
following is displayed followed by the "Exit Prog.
Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?" prompt is
displayed directly.
[Y], [N]
Exits program mode.
Press [N] to go back to Prompt 3.
[ESC]
Press [ESC] to load factory defaults.
Refer to the Exiting Programming Mode paragraph
in this section.
• ECP
Press the [space] key to scroll through the modes of
operation.
• Zone Trig.
Press [ENTER] to select mode.
• 4204 Emu
• Two 4204s
See Table 3 for ECP mode programming.
[01-99]
Enter the 2-digit primary city ID, 01-99 (decimal).
[01-FE]
Enter the 2-digit primary central station ID
number, 01-FE (HEX).
[0001-9999]
Enter the 4-digit subscriber account number, 0001-
9999 (decimal).
The 7845i-GSM communicates with the control
[01-15]
panel as a 4204 relay module. Enter the
appropriate address. For VISTA-10P, and
FA130CP Series control panels, this must be
address 12. For other controls, see the control
panel's Installation and Setup Guide.
NOTES:
1. The 4204 protocol limits address range to 01-15.
If using 2-4204 mode, the 7845i-GSM assigns
the second 4204 to the next higher device
address (e.g., if entering address 12 for the first
4204, then address 13 is automatically assigned
to the second 4204 module). Program the
control panel accordingly.
2. The device address(es) must be unique from the
"Direct Wire Addr" entered in Prompt 15 and
any other address used on the control panel.
[Y], [N]
Applies only to VISTA-128BP/250BP and FBP
Series controls, and FA1660C and 1700C Series
controls.
Enables Direct Wire Downloading over IP.
If [N], skip to Prompt 16: "Supervision."
DESCRIPTION
Hide quick links:
Table of Contents
