Table of Contents
GE
D
GB091046, R
IRECTION
8-11-2-5
Install BEP5 Power Supply
Follow these steps to install the BEP5 Power Supply:
1.) With the 2 pins pointing to the back of the BEP, guide the pins into the 2 holes in the top right of the
BEP. Apply a pressure to make it slide into position.
2.) With the pins in place, replace the 2 screws that secure the front of the power supply to the BEP
frame.
3.) Install the BEP Cover as described in these steps:
Be careful not to pinch any of the cables when installing the BEP Cover.
NOTICE
a.) Insert the base of the BEP Cover inside the base of the BEP.
b.) Tilt the top of the BEP Cover toward the VIVID E9 / VIVID E7.
c.) Install the fixing screw(s) for the BEP Cover:
4.) Replace the Left Side Cover.
8 - 240
2
EVISION
Be sure the bottom lip of the BEP Cover rests inside the BEP.
-
On BEP6 there are two finger screws on the top of the BEP Cover.
Section 8-11 - Back End Processor (BEP) parts replacement
VIVID E9 / VIVID E7 BT'13 S
M
ERVICE
ANUAL
- Quick Links:
- Configuration
Hide quick links:
Chapters
Table of Contents
Troubleshooting
