Table of Contents
Chapter 6 Replacing the Consumables
6
Attach a new pick roller unit.
1 Insert the end of the shaft into the slot while holding the bushing, and
insert the other end to the left.
Slot
Pick Roller
Unit
1
Bushing
2
2 Rotate the bushing until it clicks in the direction of the arrow.
Bushing
ATTENTION
Check that the pick roller unit is attached properly. Otherwise, it
may cause feeding errors such as paper jams.
7
Close the ADF cover.
For details, refer to
"1.4 Opening/Closing the ADF" (page
Be careful not to have your fingers caught
when the ADF cover closes.
8
Plug the power cable, and turn on the scanner.
For details, refer to
"1.3 Turning the Power ON/OFF" (page
9
Reset the sheet counter in the Software Operation Panel.
For details, refer to
"Resetting the Sheet Counters" (page
TOP
Contents
Index
20).
Introduction
Scanner
Overview
How to Load
19).
Documents
102).
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
64
Table of Contents
