Table of Contents
9.2
Repair
Special expertise and tools are required for many
repairs. For this reason, repairs may only be
carried out at a specialist dealer. These include:
Replacing tires and rims
•
Replacing rims, brake pads and brake rotors
•
•
Replacing and tensioning the chain.
9.2.1
Original parts and lubricants
The individual ebike parts have been carefully
selected and matched to one other.
Only original parts and lubricants must be used for
maintenance and repair.
The constantly updated accessory approval and
parts lists are in Section 11, Documents and
Drawings.
Follow the operating instructions for the new
components.
9.2.2
Replacing the lighting
Only use components of the respective power
class for replacement.
9.2.3
Setting the front light
The front light must be set so that its light beam
shines on the road 30 feet in front of the ebike.
Troubleshooting, fault clearance and repair
Checking tire clearance
9.2.4
The tire needs to be checked each time a
suspension fork tire is changed to another size.
1 Release pressure from the fork.
2 Press fork together fully.
3 Measure the gap between the top of the tire
and the crown's lower surface. The gap must
not be less than 10 mm. If the tire is too large,
the tire will touch the crown's lower surface if
the fork is fully pressed together.
4 Release pressure on fork and pump it up again
if it is an air suspension fork.
5 Take into account the fact that the gap will be
smaller if there is a guard. Check again to
ensure that there is sufficient clearance for
the tire.
201
Chapters
Table of Contents
