Table of Contents
9.1.6
Other errors
Symptom
Cause
Two beeps will sound if a
Pressed switch mode has been
switch is pressed but the
deactivated.
switch cannot be
operated.
Three beeps are
A fault or warning has
sounded.
occurred.
If an electronic shifter is
This is because the computer sets the
used, pedal assistance
pedal assistance to the optimum level.
becomes weaker when
the gear is changed.
A noise can be heard
after switching.
The shifter setting may not have
It is normal to hear a
noise coming from the
been made properly.
rear wheel when cycling
as normal.
If the ebike is brought to
You may have applied too much
a stop the ebike, the
pressure on the pedals.
gear transmission does
not switch to the position
pre-configured in the
functional feature.
Table 52: Other drive system errors
Troubleshooting, fault clearance and repair
Remedy
This is not a malfunction.
This occurs when a warning or an error is shown on the on-
board computer. Follow the instructions for the code indicated
on screen in Section 6.2 System Messages.
This is not a malfunction.
Contact your specialist dealer.
Contact your specialist dealer.
Press on the pedals only gently to make it easier to change the
transmission.
192
Chapters
Table of Contents
