Documenting The Settings For The Basic Functions, Firmware V4.4 - Siemens SINAMICS G120 Operating Instructions Manual
Low voltage inverters
built-in units with cu250s-2 control units and
encoder evaluation
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Appendix
A.6 Acceptance tests for the safety functions
A.6.4
Documenting the settings for the basic functions, firmware V4.4 ... V4.7 SP6
Drive =
Table A-10
Firmware version
Name
Control Unit firmware version
SI version, safety functions integrated in the drive (processor 1)
Table A-11
Monitoring cycle
Name
SI monitoring clock cycle (processor 1)
Table A-12
Checksums
Name
SI module identifier, Control Unit
SI module identifier, Power Module
SI reference checksum SI parameters (processor 1)
SI reference checksum SI parameters (processor 2)
Table A-13
Settings of the safety functions
Name
SI enable, functions integrated in the drive
Only for the CU250S-2 Control Unit
SI PROFIsafe address
F-DI switch over discrepancy time
SI STO debounce time
Only for the CU250S-2 Control Unit
SI forced dormant error detection timer
SI forced checking procedure STO via PM terminals time
Table A-14
Safety logbook
Name
SI change control checksum
SI change control checksum
SI change control time stamp
SI change control time stamp
518
SI enable safe brake control
SI Safe Stop 1 delay time
Operating Instructions, 04/2018, FW V4.7 SP10, A5E31759476B AG
Number
Value
r18
r9770
Number
Value
r9780
Number
Value
r9670
r9672
p9799
p9899
Number
Value
p9601
p9602
p9610
p9650
p9651
p9652
p9659
p9661
Number
Value
r9781[0]
r9781[1]
r9782[0]
r9782[1]
Converter with the CU250S-2 Control Units
Table of Contents
