Pressure Roller Center Thermistor (Thm4 Pressure Roller Rear Thermistor (Thm5) - Toshiba e-STUDIO2330C Service Manual
Hide thumbs
Also See for e-STUDIO2330C:
- Service handbook (512 pages) ,
- Management manual (226 pages) ,
- Copying manual (174 pages)
Table of Contents
Note:
When installing, be careful not to insert the
tab terminal between the insulating tube and
the terminal.
16.6.12 Pressure roller center thermistor (THM4) / Pressure roller rear
thermistor (THM5)
(1)
Take off the pressure roller and pressure
roller.
P.16-19 "16.6.5 Pressure roller cover"
P.16-21 "16.6.8 Pressure roller / Pressure
roller lamp (LAMP3)"
(2)
Release the harness out of the 4 clamps.
(3)
Remove 1 screw and then take off the
pressure roller rear thermistor bracket.
(4)
Remove 2 screws and then take off the
pressure roller center thermistor bracket.
(5)
Remove 1 screw and take off the pressure
roller rear thermistor.
(6)
Remove 2 screws, and then release the
harness out of 1 clamp to take off the
pressure roller center thermistor.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Harness
Fig. 16-51
Pressure roller
rear thermistor bracket
Clamp
Fig. 16-52
Pressure roller rear
thermistor
Pressure roller
center thermistor
Fig. 16-53
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
16 - 33
Insulating tube
Terminal
Tab terminal
Pressure roller
center thermistor bracket
Clamp
FUSER UNIT / PAPER EXIT SECTION
16
Hide quick links:
Chapters
Table of Contents
Troubleshooting
