Toshiba e-STUDIO2330C Service Manual page 380
Hide thumbs
Also See for e-STUDIO2330C:
- Service handbook (512 pages) ,
- Management manual (226 pages) ,
- Copying manual (174 pages)
Table of Contents
(5)
Remove 2 screws, and then take off the rear
bracket.
(6)
Fold the frame with its rear side up.
(7)
Pull out the transfer belt.
Notes:
1. Install the transfer belt in the middle so
that it does not move to one side.
2. Install the transfer belt so that the serial
number inside of the belt comes at the
rear side.
3. Do not touch the belt surface directly with
bare hands.
4. Be sure not to scratch the belt surface.
5. When the belt is being replaced, clean its
drive roller, 2nd transfer facing roller,
tension roller and idling roller with alcohol.
6. Check if the rib on both ends of the
transfer belt does not run on the rollers.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Rear bracket
Fig. 14-22
Frame
Fig. 14-23
Fig. 14-24
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
14 - 17
Transfer belt
TRANSFER UNIT
14
Hide quick links:
Chapters
Table of Contents
Troubleshooting
