Toshiba e-STUDIO2330C Service Manual page 147
Hide thumbs
Also See for e-STUDIO2330C:
- Service handbook (512 pages) ,
- Management manual (226 pages) ,
- Copying manual (174 pages)
Table of Contents
Notes:
Be sure to install the lamp harness by
following the procedure below.
1. Clean the seal adhering surface with
alcohol.
2. Align the black line on the lamp harness
with the position as shown in the figure,
and fix it with a seal.
3. Align the bent portion of the lamp harness
with the position as shown in the figure,
and fix it with a seal.
4. After the installation, move carriage-1
towards the left and confirm that there is
no abnormality in the lamp harness, such
as twisting.
(5)
Rotate the carriage-1 in the direction shown
in the figure at right, not to touch the mirror.
Then take off the carriage-1.
Note:
When replacing the mirror-1, replace the
carriage-1 together with mirror-1.
Mirror-1 should not be removed.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 7-38
Fig. 7-39
Fig. 7-40
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
7 - 23
7
SCANNER
Hide quick links:
Chapters
Table of Contents
Troubleshooting
