Toshiba e-STUDIO2330C Service Manual page 426
Hide thumbs
Also See for e-STUDIO2330C:
- Service handbook (512 pages) ,
- Management manual (226 pages) ,
- Copying manual (174 pages)
Table of Contents
(5)
Remove the spring, and then take off the
separation fingers.
16.6.8
Pressure roller
(1)
Take off the front side covert.
P.16-18 "16.6.2 Front side cover"
(2)
Take off the separation finger unit.
P.16-20 "16.6.7 Separation finger unit /
Separation finger"
(3)
Release the harness on the front side out of
1 clamp, and then disconnect 1 relay
connector.
(4)
Release the harness on the rear side out of 2
clamps and the harness guide, and then
disconnect 1 relay connector.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Separation finger
Spring
/ Pressure roller lamp (LAMP3)
16 - 21
Fig. 16-19
Clamp
Relay connector
Fig. 16-20
Clamp
Relay connector
Fig. 16-21
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
FUSER UNIT / PAPER EXIT SECTION
16
Hide quick links:
Chapters
Table of Contents
Troubleshooting
