Asr 5000 Installation Guide - Cisco ASR 5000 Installation Manual
Hide thumbs
Also See for ASR 5000:
- Administration manual (466 pages) ,
- Installation manual (37 pages) ,
- Installation procedure (8 pages)
Table of Contents
Installing Application Cards
During installation, maintenance, and/or removal, wear grounding wrist and/or heel straps to avoid ESD
Caution
damage to the components. Failure to do so could result in damage to electrical components and could
potentially void your warranty.
Step 1
Determine the type of application card you are installing. Each application card is identified by the text near the bottom
of its front panel.
Step 2
Determine which chassis slot to install the card in based on the information in
on page
67..
Step 3
Remove the blanking panel, if one is installed, covering the slot.
a) Use a Phillips #2 screwdriver to loosen the screws at the top and bottom of the blanking panel.
b) Holding the screws on the blanking panel, pull the blanking panel away from the chassis to expose the chassis slot.
Step 4
Slide the interlock switch on the card fully downward and flip both ejector levers fully outward and away from the front
panel.
Step 5
Properly support the weight of the card and align it with the upper and lower card guides of the chassis slot. Gently slide
the card into the slot until the levers touch the chassis frame.
Take extra caution when installing packet processing cards. These cards contain heat sinks that could become
Caution
loose or be damaged if they come into contact with another card while it is being inserted in the chassis slot.
ASR 5000 Installation Guide
70
Application Card Installation
Chassis Slot Numbering and Assignments,
Table of Contents
