Asr 5000 Installation Guide - Cisco ASR 5000 Installation Manual
Hide thumbs
Also See for ASR 5000:
- Administration manual (466 pages) ,
- Installation manual (37 pages) ,
- Installation procedure (8 pages)
Table of Contents
Cabling the Switch Processor Input/Output Line Card
Table 32: 1000Base-SX SFP Connector and Fiber Optic Cable Types
Module Type
1000Base-SX
The SFP interface is only certified to work with SFP transceiver modules purchased from Cisco for use
Important
with the SPIO card.
Be sure to label the interface cables with their destination prior to connecting them to the SPIO card. This
Important
will assure proper reconnection should the card need to be serviced.
Class 1 Laser Device
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Invisible laser radiation may be emitted from the aperture of the port when no cable is connected. Avoid
exposure to laser radiation and do not look into open apertures. Be sure to keep the cover on the interface
when it is not in use.
Laser Klasse 1 - nur speziell ausgebildetes Personal darf dieses Geraet warten.
Nicht in den Laser schauen, um Augenverletzungen zu vermeiden.
Nicht genutzte Buchsen mit der entsprechenden Kappe verschliessen.
Each optical SFP interface is equipped with a transmit (TX) port and a receive (RX) port as shown in the
following figure.
Figure 30: SPIO Optical SFP Interface Connector
Additionally, the SPIO provides two light emitting diode (LED) status indicators for this interface:
• Link: This green LED shows whether or not the line card is connected to the network. The LED is
illuminated when the card is connected.
Connector Type
Cable Specifications
Fiber, LC duplex
Fiber Type: Multi-mode fiber (MMF), 850 nm wavelength
female connector
Core Size (microns)/Range:
• 62.5/902.23 feet (275 meters)
• 50/1640.42 feet (500 meters)
Minimum Tx Power: -9.5 dBm
Rx Sensitivity: -17 dBm
Using the SFP Interfaces
ASR 5000 Installation Guide
89
Table of Contents
