Panasonic LP-GS Series Setup & Maintenance Manual page 28
Laser marker
Hide thumbs
Also See for LP-GS Series:
- Operation manual (358 pages) ,
- Serial communication command manual (208 pages) ,
- Quick reference (46 pages)
Table of Contents
2.
Signal connector: SIGNAL
This is the terminal for communicating between head and controller.
Connect the attached signal cable.
3.
Power connector: POWER
This is the connector for supplying the power to the head.
Connect the attached unit power cable.
4.
Frame ground terminal: F.G.
This is the terminal for ground. Ground this terminal to the earth permanently.
5.
Laser emission port
The emission port of the marking laser and the guide laser for LP-GS051(-L).
6.
Laser pointer emission port
From this port the red laser pointer radiates in oblique direction for the guide pointer function. The pointer radiates
also when using the work distance indication by the guide laser for LP-GS051(-L). Refer to "2-3-4 Marking position
check" (P.39).
To use these guide laser functions, do not seal the laser pointer emission port at the installation.
7.
Head air-cooling inlet
The air-cooling inlet for the head. Fans and a filter are installed.
8.
Head air-cooling outlet
The air-cooling outlet for the head.
28
ME-LPGS-SM-8
- Quick Links:
- Product Configuration
Hide quick links:
Table of Contents
Troubleshooting
