D-Link DXS-3600 Series Reference Manual page 87
Dxs-3600 series layer 2/3 managed 10gigabit ethernet switch
Hide thumbs
Also See for DXS-3600 Series:
- Cli reference manual (1456 pages) ,
- Reference manual (680 pages) ,
- Hardware installation manual (55 pages)
Table of Contents
DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to configure the console session to never timeout.
Switch# configure terminal
Switch(config)# line console
Switch(config-line)# session-timeout 0
Switch(config-line)#
5-21 terminal width
The command is used to set the number of character columns on the terminal screen for the current
session line. The terminal width command will only affect the current session. The terminal width default
command will set the default value, but it doesn't affect any current sessions.
terminal width default NUMBER
no terminal width default
Parameters
NUMBER
Default
By default, this value is 80 characters.
Command Mode
Use the EXEC Mode or Privilege EXEC Mode for the terminal width command.
Use the Global Configuration Mode for the terminal width default command.
Command Default Level
Level: 1 (for the terminal width command).
Level: 12 (for the terminal width default command).
Usage Guideline
By default, the switch's system terminal provides a screen display width of 80 characters. The terminal
width command changes the terminal width value which applies only to the current session. When
changing the value in a session, the value applies only to that session. When the no form of this
command is used, the number of lines in the terminal display screen is reset to the default, which is 80
characters.
The terminal width default command is available in the global configuration mode. The command
setting does not affect the current existing terminal sessions but affect the new terminal sessions that are
activated later and just the global terminal width value can be saved.
However, for remote CLI session access such as Telnet, the auto-negotiation terminal width result will
take precedence over the default setting if the negotiation is successful. Otherwise, the default settings
take effect.
Example
This example shows how to adjust the current session terminal width to 120 characters.
Switch# show terminal
Length: 24 lines
Specifies the number of characters to display on the screen. Valid
values are from 40 to 255.
87
Table of Contents
