D-Link DXS-3600 Series Reference Manual page 162
Dxs-3600 series layer 2/3 managed 10gigabit ethernet switch
Hide thumbs
Also See for DXS-3600 Series:
- Cli reference manual (1456 pages) ,
- Reference manual (680 pages) ,
- Hardware installation manual (55 pages)
Table of Contents
DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
A default router-ID will be assigned.
If loopback interfaces are not configured, the router ID is set to the highest IP address of interfaces.
If loopback interfaces are configured, the router ID is set to the highest IP address of loopback interfaces.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the router ID for the local BGP routing process. The router ID must be a
uniquely assigned within the network.
Example
This example shows how to change the router ID to 192.168.1.1.
Switch# configure terminal
Switch(config)# router bgp 65100
Switch(config-router)# bgp router-id 192.168.1.1
10-23
bgp scan-time
This command is used to configure the BGP scan timer value. The BGP router will periodically check
whether the next hop is reachable from the BGP route. Use the no form of command to reset to default
setting.
bgp scan-time SCAN-INTERVAL
no bgp scan-time
Parameters
SCAN-INTERVAL
Default
By default, this value is 60 seconds.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the router is enabled for scanning next hop of BGP routes, the router will periodically check
whether there is a route to reach the next hop in the routing table.
Example
This example shows how to sets the scan-timer to 30 seconds.
Switch# configure terminal
Specifies the BGP scan timer value from 5 to 60 seconds.
162
Table of Contents
