D-Link DXS-3600 Series Reference Manual page 981
Dxs-3600 series layer 2/3 managed 10gigabit ethernet switch
Hide thumbs
Also See for DXS-3600 Series:
- Cli reference manual (1456 pages) ,
- Reference manual (680 pages) ,
- Hardware installation manual (55 pages)
Table of Contents
DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the override option is not specified, the CoS of the packets will be the packet's CoS if the packets
are tagged, and will be the port default CoS if the packet is untagged.
When the override option is specified, the port default CoS will be applied to all packets received by the
port. Use the override keyword when all incoming packets on certain ports deserve a higher or lower
priority than packets that enter from other ports. Even if a port was previously set to trust DSCP or CoS,
this command overrides that trust state, and all CoS values on the incoming packets are changed to the
default CoS value that is configured with the mls qos cos command. If an incoming packet is tagged, the
CoS value of the packet is modified at the ingress port.
For packets arriving at the 802.1Q VLAN tunnel port, the port default CoS will be both the internal CoS
assigned to the packet, and the CoS value in the tunnel VLAN tag of the transmitted packet.
Example
This example shows how the default CoS of Ethernet port 3/0/1 is set to 3.
Switch# configure terminal
Switch(config)# interface
switch(config-if)# mls qos cos 3
switch(config-if)#
82-6 mls qos dscp-mutation
This command is used to attach an ingress Differentiated Services Code Point (DSCP) mutation map to
the interface. To remove the ingress DSCP mutation map association from the interface, use the no form
of this command.
mls qos dscp-mutation DSCP-MUTATION-TABLE-NAME
no mls qos dscp-mutation
Parameters
DSCP-MUTATION-TABLE-
NAME
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
eth3/0/1
Specifies the name of the DSCP mutation table. The string of the
name is up to 32 characters and no space is allowed.
981
Table of Contents
