D-Link DXS-3600 Series Reference Manual page 939
Dxs-3600 series layer 2/3 managed 10gigabit ethernet switch
Hide thumbs
Also See for DXS-3600 Series:
- Cli reference manual (1456 pages) ,
- Reference manual (680 pages) ,
- Hardware installation manual (55 pages)
Table of Contents
DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
SECONDS
Default
By default, this value is 185 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the DR receives multicast stream, it will send register message to the RP of the group. And when
the RP receives this message, it would set up a timer for this (S, G) entry. This command configures the
value of this timer.
Example
This example shows how to configure the PIM register keep-alive time to 500 seconds.
Switch# configure terminal
Switch(config)# ip pim rp-register-kat 500
Switch(config)#
79-13
ip pim spt-threshold
This command is used to configure the condition to switch over to the source tree. Use the no form of the
command to revert to the default setting.
ip pim spt-threshold {0 | infinity}
no ip pim spt-threshold
Parameters
0
infinity
Default
By default, this option is infinity.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command on the last hop of the router. In the PIM-SM mode, initially the multicast traffic from the
source will be flowing along the RPT share tree to the receiver. After the first packet arrives at the last
hop router, for each group of traffic, it can operate in one of the following two modes. With the mode
Specifies the keep alive time, in the range from 1 to 65525 seconds.
Specifies to establish the source tree right at the arrival of the first
packet.
Specifies to always rely on the shared tree.
939
Table of Contents
