D-Link DXS-3600 Series Reference Manual page 640
Dxs-3600 series layer 2/3 managed 10gigabit ethernet switch
Hide thumbs
Also See for DXS-3600 Series:
- Cli reference manual (1456 pages) ,
- Reference manual (680 pages) ,
- Hardware installation manual (55 pages)
Table of Contents
DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to configure the LACP system priority to be 30000.
Switch# configure terminal
Switch(config)# lacp system-priority 30000
Switch(config)#
57-5 port-channel load-balance
This command is used to configure the load balance algorithm that the switch uses to distribute packets
across ports in the same channel. To reset the load distribution to the default settings, use the no form of
this command.
port-channel load-balance {dst-ip | dst-mac | src-dst-ip | src-dst-mac | src-ip | src-mac | dst-l4-
port | src-dst-l4-port | src-l4-port}
no port-channel load-balance
Parameters
dst-ip
dst-mac
src-dst-ip
src-dst-mac
src-ip
src-mac
dst-l4-port
src-dst-l4-port
src-l4-port
Default
The default load balance algorithm is src-dst-mac.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to specify the load balance algorithm. Only one algorithm can be specified.
Example
This example shows how to configure the load balance algorithm as src-ip.
Switch# configure terminal
Specifies that the switch should examine the IP destination address.
Specifies that the switch should examine the MAC destination address.
Specifies that the switch should examine the IP source address and IP
destination address.
Specifies that the switch should examine the MAC source and MAC
destination address.
Specifies that the switch should examine the IP source address.
Specifies that the switch should examine the MAC source address.
Specifies that the switch should examine the Layer 4 destination
TCP/UDP port.
Specifies that the switch should examine the Layer 4 source TCP/UDP
port and Layer 4 destination port
Specifies that the switch should examine the Layer 4 source TCP/UDP
port.
640
Table of Contents
