Table of Contents
Receiving Multiprocessor Serial Data: Figure 11-12 shows a sample flowchart for receiving
multiprocessor serial data and indicates the procedure to follow.
Initialize
Start receiving
Set MPIE bit to 1 in SCR
Read ORER and FER flags in SSR
∨
FER
ORER = 1 ?
No
Read RDRF flag in SSR
No
RDRF = 1?
Yes
Read receive data from RDR
No
Own ID?
Yes
Read ORER and FER flags in SSR
∨
FER
ORER = 1 ?
No
Read RDRF flag in SSR
RDRF = 1?
Yes
Read receive data from RDR
No
Finished receiving?
Yes
Clear RE bit to 0 in SCR
End
Figure 11-12 Sample Flowchart for Receiving Multiprocessor Serial Data (1)
1
1.
SCI initialization: the receive data function
of the RxD pin is selected automatically.
2.
ID receive cycle: set the MPIE bit to 1 in SCR.
3.
SCI status check and ID check: read SSR,
check that the RDRF flag is set to 1, then read
2
data from RDR and compare with the
processor's own ID. If the ID does not match,
set the MPIE bit to 1 again and clear the
RDRF flag to 0. If the ID matches, clear the
RDRF flag to 0.
4.
SCI status check and data receiving: read
Yes
SSR, check that the RDRF flag is set to 1,
then read data from RDR.
5.
Receive error handling and break detection:
3
if a receive error occurs, read the
ORER and FER flags in SSR to identify the error.
After executing the necessary error handling,
clear the ORER and FER flags both to 0.
Receiving cannot resume while either the ORER
or FER flag remains set to 1. When a framing
error occurs, the RxD pin can be read to detect
the break state.
Yes
4
No
5
Error handling
(continued on next page)
329
Chapters
Table of Contents
