Table of Contents
CHAPTER
3
The most commonly used commands are the System-Level Commands. These are
used to load and store graphics information, in addition to printer control. System-
Level Commands are used to override default parameter values (fixed and selectable)
and may be used before or after Immediate Commands but cannot be issued among
Label Formatting Commands.
System-Level Commands consist of:
l
l
l
STX A Set Time and Date
l
STX a Enable Feedback Characters
l
STX B Get Printer Time and Date Information
l
STX c Set Continuous Paper Length
l
STX E Set Quantity for Stored Label
l
STX e Select Edge Sensor
l
STX F Form Feed
l
STX f Set Form Stop Position (Backfeed Command)
l
STX G Print Last Label Format
l
STX I Input Image Data
l
STX i Scalable Font Downloading
l
STX J Set Pause for Each Label
l
STX k Test Communication Port
l
STX L Enter Label Formatting Command Mode
l
STX M Set Maximum Label Length
l
STX m Set Printer to Metric Mode
l
STX n Set Printer to Imperial Mode
l
DPL Command Reference
SYSTEM LEVEL COMMANDS
Attention-Getter, 0x02 or 0x7E (see
Command Character
Parameters (if any)
Control Code Command
Functions)
9
Table of Contents
