Table of Contents
Value
Units/Interpretation
B
Enable / Disable Y, N
Sample
Result
The example configures the printer to back up and print a one-inch tall "VOID"
message on a faulted label; if two successive faults occur during the printing of that
label, then the FEED Key must be pressed to clear the fault.
FM Feedback Mode
See a for command details.
Parameter:
Value / Range:
Units / Interpretation:
Command Equivalent:
FS Slew Speed
This command controls the rate of label movement between printing areas when the
GPIO port is used.
Parameter
Value / Range:
Units / Interpretation:
Command Equivalent:
GA Alternate Gap Type
This command selects one of two Gap Sensing algorithms. This parameter is valid for
the RL3e /RL4e when Sensor Type is set to Gap. Defaults to Disabled or Alternate not
selected.
Parameter
Value / Range:
Units / Interpretation:
Command Equivalent:
DPL Command Reference
Selection/Definition
Retract from presented distance prior to feed-clear motion. This
option is intended for use with applicator equipment that may
require certain GPIO signals for proper operation.
FM
Y, N
Y = Enabled, N = Disabled
FS
Alpha character
Model specific ranges (see
GA
E, D
E = Enable, D = Disabled
N/A
Speed
Ranges).
89
Table of Contents
