Table of Contents
IEC 62591 Wireless Interface Instruction Manual (for ROC800-Series and FloBoss 107)
1.2.3
1.3 Configuration/Commissioning Software
Emerson Process
Management
Field Tools
1-4
Figure 1-3. Emerson Wireless 781 Field Link
For instructions on installing the Field Link in the field, refer to Chapter
2, Installation.
WirelessHART Field Devices
The two components of Remote Automation Solutions' IEC 62591
Wireless Interface provide you with the ability to manage signals from a
network of WirelessHART field devices. The physical configuration of
the IEC 62591 Wireless Interface is based on the controller (FB107 or
ROC800) and the total number of field devices. A ROC800
implementation supports up to 60 devices, while a FB107
implementation supports up to 20 devices.
Remote Automation Solutions supports transmitters that conform to the
WirelessHART protocol. For a current list of the transmitters Remote
Automation Solutions has tested with the IEC 62591 Interface, refer to
the following product data sheets (available at
www.EmersonProcess.com/Remote):
™
▪
FloBoss
107 IEC 62591 Interface (part D301713X012)
▪
ROC800-Series IEC 62591 Interface (part D301712X012)
The release of the IEC 62591 Wireless Interface enables Remote
Automation Solutions to introduce Emerson Process Management Field
Tools. Field Tools is a comprehensive software solution that folds
several Remote Automation Solutions configuration software tools –
ROCLINK™, ControlWave Designer, and TechView, among others –
into one point-of-access tool. Field Tools simplifies the process of
configuring both wired and wireless HART devices.
General Information
Revised June-2018
Table of Contents
Troubleshooting
