Chapter 3 - Configuration And Commissioning - Emerson IEC 62591 Instruction Manual

IEC 62591 Wireless Interface Instruction Manual (for ROC800-Series and FloBoss 107)

In This Chapter

Revised June-2018

3.1

Overview .......................................................................................... 3-2

3.1.1 Configuring Devices and Planning the Network ................... 3-2

3.1.2 Network ID and Join Key ...................................................... 3-3

3.2

IEC 62591 Module Interface (FB107) .............................................. 3-4

3.2.1 Commissioning Devices ....................................................... 3-8

3.2.2 Managing Device Information............................................. 3-10

3.2.3 Viewing Network Statistics ................................................. 3-17

3.2.4 Retrieving a Diagnostic Log ............................................... 3-20

3.2.5 Displaying Commissioned Transmitters ............................. 3-21

3.3

IEC 62591 Module Interface (ROC800) ........................................ 3-22

3.3.1 Accessing the Network ....................................................... 3-24

3.3.2 Commissioning Devices ..................................................... 3-26

3.3.3 Managing Device Information............................................. 3-29

3.3.4 Viewing Network Statistics ................................................. 3-35

3.3.5 Retrieving a Diagnostic Log ............................................... 3-38

3.4

Updating Module Firmware ............................................................ 3-39

(ROC800/FloBoss 107) .................................................... 3-40

After you have wired the Field Link to the IEC 62591 module and

applied power to the module, you use the AMS Device Configurator to

configure transmitters for the wireless network. You then use

ROCLINK 800 to activate (or "commission") each WirelessHART

device into the entire network. Both of these software tools are available

as part of Field Tools.

: Refer to the Emerson Field Tools Quick Start Guide (part

Note

D301703X412) for complete instructions on using AMS Device

Configurator to configure the WirelessHART devices with the

long tag name, Network ID, and Join Key.

Keep in mind that configuration and commissioning is a two-step

process for each device:

1. Configure each device using Field Tools' AMS Device Configurator

and a HART modem (or you can use a hand-held configuration

device such as the Emerson 375 or 475 Field Communicator).

During this step you individually add network information (Network

ID, Join Key, and long tag name) to the field- based wireless device.

2. Use ROCLINK 800 to configure the network by commissioning the

device as a working part of the network.

: The commissioning process assumes that you have already

Note

placed and powered up a number of WirelessHART devices in

the field.

Configuration and Commissioning

™

Adapter ................................................ 3-3

3-1