Table of Contents
2 Installation and commissioning
2.6.1. Introduction
2.6 Restricting the working range
2.6.1. Introduction
General
When installing the robot, make sure that it can move freely within its entire working space.
If there is a risk that it may collide with other objects, its working space should be limited.
The working range of the following axis may be restricted:
This section describes how to install hardware that restricts the working range.
Notice that adjustments must also be made in the software. References to software manuals
are given in the following installation procedures.
92
•
Axis 1, hardware (mechanical stop) and software.
•
Axis 2, hardware (mechanical stop) and software
•
Axis 3, hardware (mechanical stop) and software
3HAC026876-001 Revision: C
Table of Contents
